This is Geekworm design metal case for the Orange Pi 4, not for Orange Pi 4B. You can refer to N400B if you want a metal case for Orange Pi 4B;
It reserves all the interfaces of the orange pi 4 motherboard, supports the cooling fan, supports the extraction of the GPIO cable, and also reserves 2 antenna holes for you to replace the antenna that comes with the motherboard.
Note: Only compatible with Orange Pi 4, NOT compatible with Orange Pi 4B!!!!You can refer to N400B if you want a metal case for Orange Pi 4B;
I can't understand why the naming of orange pi is so confusing. . . .
- Nice appearance
- Good heat dissipation
- Reserved GPIO cable hole
- All ports and slots of the case can match with orange pi 4 board perfectly
- Good wifi signal, reserves many round cooling holes on the side of the case, almost no weakeness for the WIFI signal;
- 2 antenna holes are reserved to facilitate the installation of external antennas
- High quality metal material with surface galvanized process;
- Case size:9.6x6.2x3.5cm/3.77x2.44x1.37inch
- with VESA mounting hole, you can hang it on the wall or somewhere you want
- About the cooling fan, the fan label marks 12V but it is also ok to use with your orange pi board.
- 1 x Orange pi 4 metal case
- 1 x Cooling fan
- 1 x Installation screws pack