Related changes
Jump to navigation
Jump to search
Enter a page name to see changes on pages linked to or from that page. (To see members of a category, enter Category:Name of category). Changes to pages on your Watchlist are in bold.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
26 April 2024
|
|
23:43 | (Comments log)[88.196.227.54; 74.111.99.142; 70.134.61.105; 185.195.233.147] | |||
|
|
23:43 185.195.233.147 talk posted a new comment on How to update eeprom firmware (Changed the line in /etc/fstab to rw instead of ro. It might also be possible to completely remove ro/rw and leave blank. sudo nano /etc/fstab) | ||||
|
|
12:40 74.111.99.142 talk posted a new comment on X450 (Can the 3.5mm headphones jack be used as output as well?) Tags: Mobile web edit, Mobile edit | ||||
|
|
09:03 70.134.61.105 talk posted a new comment on P252 (All four screws are the same length, though they should not be as the ones toward the middle of the case stand proud.) | ||||
|
|
02:21 88.196.227.54 talk posted a new comment on X735-script (Any way to configure PWM in Home Assistant OS since it does not have apt, wget, etc?) | ||||
25 April 2024
| 02:55 | Comments log 73.22.53.193 talk posted a new comment on X1011 (I would like to create a NAS, Raid 5 out of this, are you planing to release instructions to do so?) | ||||
24 April 2024
|
|
17:14 | (Comments log)[77.189.215.199; 185.65.135.178 (2×)] | |||
|
|
17:14 185.65.135.178 talk posted a new comment on How to update eeprom firmware (I did the as the instruction says, but getting error. sudo apt update sudo apt upgrade sudo rpi-eeprom-update -a Not sure how to get around this problem: /usr/bin/rpi-eeprom-digest: 92: cannot create /boot/firmware/pieeprom.sig: Read-only file system I am running the latest Raspberry Pi OS 64-bit, a X1001 with a 1TB 2280 SSD and mSD is not inserted so the Pi5 starts and runs from the SSD. Have also been trying to set the eeprom for low power consumption when in stand by mode: sudo rpi-eep...) | ||||
|
|
16:57 185.65.135.178 talk posted a new comment on X1001 (Integrated with XH2.54 5V power connector. It is, but what is not supplied or offered is a short cable to connect to the Pi5 board. And yes, my Pi5 is working great with the X1001 and a 1TB 2280 SDD. The dtparam=pciex1_gen=3 has been set and the microSD has been removed. So I don't really need the extra power connector, but it should have been included anyways just to be on the safe side.) | ||||
|
|
04:08 77.189.215.199 talk posted a new comment on X1002 (Crucial P3 Plus 500 GB works after update to eeprom firmware 2024 - 04 - 20) | ||||
23 April 2024
|
|
04:54 | (Comments log)[47.181.223.243; 136.23.0.128] | |||
|
|
04:54 47.181.223.243 talk posted a new comment on X650 (Resolved. Board v.1.5 is still using pcf8563 not ds1307 so no change in config.txt is necessary.) | ||||
|
|
02:47 136.23.0.128 talk posted a new comment on X1011 (I would also like a case produced. Thanks) Tags: Mobile web edit, Mobile edit | ||||
22 April 2024
|
|
15:48 | (Comments log)[90.77.46.17; 177.99.103.158; 108.76.201.4 (2×)] | |||
|
|
15:48 90.77.46.17 talk posted a new comment on XScript (If I do not install the script, I can still switch on and switch off my Pi4 with the X-C1 board. Is that save or is it like a hard shut off which might corrupt my SD card?) | ||||
|
|
05:33 108.76.201.4 talk posted a new comment on X1001 (I posted as anon user #15 earlier. I think I got the problem resolved by routing the cable a little differently. I noticed I did not have the problem if the device was outside of the case (Geekworm P579-V2-K). I tried adding some electrical tape to the inside of the case (per Q4), but that didn't make a difference. However, I noticed that, when the pi was installed in the case, the FCC cable was being pressed against the inside of case, which caused it to bend some and appeared to cause...) | ||||
|
|
04:04 177.99.103.158 talk posted a new comment on X1001 (Is there a way to disable the LED light, its so annoying.) | ||||
|
|
01:14 108.76.201.4 talk posted a new comment on X1001 (I've installed the X1001 with a 128GB Silicon Power P24A60 (Model A60), and it has booted and ran fine for at least an hour or so, then everything just stops responding and basic commands like sudo and ls are no longer found. It behaves as though the drive has being disconnected, but the blue light is still on when this happens. I have re-seated the FCC cable on both ends a few times. It seems to be seated fully and securely. Also, the drive is typically recognized (at least momentarily)...) | ||||
21 April 2024
| 09:39 | Comments log 212.102.44.164 talk posted a new comment on X-UPS1 (When multiple boards are stacked can I use the outputs on all boards, or only the first? Thanks!) | ||||