Changes

X635-Software

4 bytes removed, 19:40, 24 April 2023

no edit summary

<big>X635 Software Guide base on Raspberry Pi OS bullseye</big>

#. * To use the HDMI to CSI-2 bridge, you will need to enable '''[[How to enable camera support in Raspberry Pi OS|Enable legacy camera support]]'''.

#. * Again open a terminal window and type the following command:

sudo wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin

#Download the required file /boot/dt-blob.bin

#. * Reboot for the dt-blob.bin file to be read

sudo reboot

#. * Open the Terminal and run the command to check if the HDMI to CSI-2 bridge is being seen by the operating system.

[[File:X635-software-15.png|700px]]

Note: You should get back <big>supported=1, detected=1</big>, indicating that the CSI-2 bridge is detected and supported by the operating system. If you get detected=0, then the CSI-2 bridge is not being seen by the operating system.

# * Connect the HDMI in device to x635 carrier board.

<big>IMPORTANT! The HDMI to CSI-2 bridge only accepts HDMI input: 1080p30, 1080p25, 720p30, 720p25</big>

Harry

Bureaucrats, Comment administrators, Interface administrators, Administrators

5,154

edits